Tag Archives: stainless

P2459

P2459

1955/1996  40′ x 10′ x 4′  Steel Cruiser/Trawler w/Russel Brothers Hull Comes w/Trailer

Price: $50,000 CDN

  • This trawler combines the classic lines of a Russel Brothers hull with all the comforts of a liveaboard!
  • Spacious superstructure was added to a Russel Brothers hull in 1996
  • Propulsion is Cummins diesel 140 hp, approx 3,000 since overhaul
  • Transmission was overhauled at same time, Twin Disc 2:1
  • Keel cooled
  • Cruises at 8.5 mph at 1350 rpm, and 2.4 gph
  • Stabilizer on each side  12″ x 12′
  • Manual davit system for lifting kayaks to upper deck
  • Dry exhaust with stainless muffler and vibration dampers
  • Prop is RH 24″ x 21″ 
  • Hull shows very little pitting
  • Dual steering stations, hydraulic steering 
  • Flybridge is 10′ x 30′
  • Fresh water capacity: 60 gal
  • Black water capacity: 60 gal
  • New 45 gal stainless fuel tank, original 75 gal mild steel heavy gauge tank as well
  • 3 anchors with 50′ of 5/16″ chain and 200′ of rope
  • Electronics: 24 mile JRC radar flat screen, 9″ Garmin touch screen GPS/Plotter, Fish finder, depth sounder, (2) VHF radios, Garmin hand-held GPS plotter
  • Floors are finished in black cherry, walls and ceiling are insulated and clad in tongue and groove cedar
  • Dickenson diesel fuel heater
  • New 12v starting system
  • Hot water on demand
  • Galley has Nova Kool fridge freezer 12v/110, propane 4-burner stove and oven
  • Generator: 2800 Honda Ultraquiet
  • 50 amp marine charger
  • Solar 430 watt panels
  • 4 x 425 ah trojan batteries
  • 2 x 8D starting batteries
  • 2 x 6v deep cell house batteries
  • All batteries new within the past 3 years
  • Accommodations: cabin down forward has 2 bunks, sofa in main area pulls out to a queen size bed
  • Headroom is 6’5 in all spaces except lower cabin
  • Head with sink and toilet, 60 gal holding tank
  • Shower on the covered aft deck with hot water on demand
  • Comes with yard trailer
  • Located near Thunder Bay, Ontario

Details are deemed to be correct but are not guaranteed and should be independently verified.

Please contact us for further information    sms@scrutonmarine.com
Scruton Marine Services    Phone 519-583-1636
Return to index

         

P2457

P2457

1980 48′ x 13′ 6  Twin Screw Steel Cruiser/Trawler 

Price: $100,000 CDN

  • Scroll down for the YouTube video walk through!
  • Draft: 44″
  • Shell plate thickness: 1/4″
  • NRT: approx 15
  • Powered by twin Chrysler Mitsubishi CM6-55 Diesel Engines, 200 hp
  • Velvet drive transmission 2.0:1
  • Cruises at 7 -8 mph
  • 4 blade brass prop on a 2″ stainless  shaft
  • Solar generator is PROwatt Xantrex
  • Fuel capacity: 200 gal (2 x 100 gal tanks)
  • Anchor winch
  • Davit 
  • Electronics: Radar, Depth finder, Loud hailer, GPS, VHF radio, compass
  • Hydraulic steering
  • Galley with 4 burner propane stove w/oven, fridge, freezer
  • Head and shower
  • Accommodations: super single in wheelhouse,  double bed in lounge and aft, cabin has 2 double beds
  • Holding tank capacity: 95 US gal approximately
  • Freshly painted, clean bilges, no rust
  • Standard safety equipment, up to date flares, 4 new fire extinguishers
  • Recent survey
  • Yard trailer available
  • Located on Nipigon Bay, Ontario

Check out the YouTube walk through in the video below!

Details are deemed to be correct but are not guaranteed and should be independently verified.

Please contact us for further information    sms@scrutonmarine.com
Scruton Marine Services    Phone 519-583-1636
Return to index

         

P2454

P2454

1983 30′ x 9′ Welded Steel Motor Boat Project Boat

Price: $9,500 CDN or Best Offer

  • This project boat has nice lines and loads of potential!
  • 3′ Draft
  • Built by Kettle Creek Boat Works, Port Stanley, Ontario, Hull #1
  • Registered tonnage: 4.5 tons
  • Engine is Perkins (1983) 4.108 51 hp diesel
  • Condition of propulsion system: not run in 8 years
  • Stainless fuel tank estimated 80 – 90 gal capacity
  • Shell plating is 3/16″ with 1/8″ on cabin sides and top
  • 2″ x 3/16″ flat bar ribs on 24″ centers
  • 1″ x 3/16″ flat bar longitudinal hull frames at 16″ centers
  • 12″ x 6″  I-beam keel with bolted on lead ballast
  • Structure has minimal pitting, hull is solid, very little surface rust
  • Custom stands included
  • Located in Amherstburg, Ontario

Details are deemed to be correct but are not guaranteed and should be independently verified.

Please contact us for further information    sms@scrutonmarine.com
Scruton Marine Services    Phone 519-583-1636
Return to index